Carson Reflex Wheel Pro2 LCD Manual de Instruções descarregar pdf (Página 26)

CARSON Reflex Wheel Pro 2 Telemetry 500500038

Many publications say that the setup sequence

for the transmitter and receiver don’t play a role

anymore with 2,4 GHz sets. However, we recom-

mend sticking to the sequence typical for previous

sets.

• Before operation: First turn on the transmitter,

then the receiver. Lastly, connect the drive bat-

tery to the control unit.

• After operation: Disconnect the battery from the

control unit. Turn the receiver off, and then the

transmitter.

• Before and after operating the transmitter, make

sure that trim is in the desired place and that all

checks have been made.

BEC receiver:

Battery eliminator is installed in the receiver

circuitry. The receiver gets supplied with current

through the drive battery that runs the engine.

NiMH battery from 6 V to 8.4 V can be used for

the receiver. Batteries of higher voltage may

damage the receiver and servos.

Use only a speed controller which has the exclusive

connector for the BEC system.

Connector motor

Connector battery

Power switch On-/Off

Steering servo

channel 1

(not included)

Receiver

Do not connect a separate power

supply to the receiver!

Electronic speed controller

(not included)

ATTENTION

Make sure that male and female connectors

have the correct polarity!

Operating Procedure

BEC-System/Connections to Receiver

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Sem comentários

Carson Reflex Wheel Pro2 LCD Manual de Instruções Página 26